Configure Dynamic Peer on Tenant BGP

You can configure a dynamic peer on a tenant BGP.

About this task

Follow this procedure to configure a dynamic peer.

Procedure

To configure BGP dynamic peer, run the following commands:

efa tenant service bgp peer create --name <peer-name> --tenant <tenant-name>
    --ipv4-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit> 
    --ipv6-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit>

The following example creates a BGP dynamic peer on tenant BGP:

efa tenant service bgp peer create --name bgpservice1 --tenant tenant1
    --ipv4-uc-dyn-nbr BL1-IP,VRF1:11.22.33.44/30,pg1,10

To update BGP dynamic peer, run the following commands:

efa tenant service bgp peer update --name <peer-name> --tenant <tenant-name>
    --operation peer-add 
    --ipv4-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit>
    --ipv6-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit>

The following example updates a BGP dynamic peer on tenant BGP:

efa tenant service bgp peer create --name bgpservice1 --tenant tenant1                             
    --operation peer-add –ipv4-uc-dyn-nbr BL1-IP,VRF1:11::22/127,pg1,20